QBrew and brewtarget versions of various recipes.

Clinton

ClintonEbadi/Cider

See also ClintonEbadi's homebrew page

Mo Hitz Mo Ale

• Pale Ale (source)

Thoth Strong Stout

• Strong Stout (sourcel)

Nowruz (نوروز) IPA

• Original Formulation (source [BrewTarget XML])

• Revision 1 (source [BrewTarget XML])

Ginger Wheat Ale

• Original Formulation (source [BrewTarget XML]

'English' IPA

• recipe forthcoming

bpt

All-Grain Wassail Ale

• Wassail Ale (source)

Wassail Ale

• Holiday Ale (source)

Brewing notes:

• 5:30pm: Began heating two quarts water to 165 ⁰F

• 5:45: Grains steeping in water (initial temperature 165 ⁰F) in 170 ⁰F oven

• 6:15: Water temperature 160 ⁰F

• 6:20: Grain sparged with 165 ⁰F water

• 6:45: Began boil; initial volume 6 gallons water and 3/4 gallons wort. Wort temperature 120 ⁰F; specific gravity 1.022 @ 120 ⁰F = 1.032

• 8.5 lbs liquid malt extract used

• 7:35: Beginning of wort boil

• 7:50: More hops (1/4 oz) added

• 1 oz hops added 15 min before end of boil

• 8:34: Final 1/2 oz of hops added, 3 min before end of boil

• 8:36: Boil ended

• Chilled to ~75 ⁰F. Final volume just over five gallons; final temperature 74 ⁰F; final specific gravity 1.066

Notes from ClintonEbadi:

• Fermentation observations:

• 2010-11-12 04:30 Fermenter @ 71⁰F. Airlock not yet bubbling, but a slight shaking results in gas release

• 2010-11-12 11:08 Fermenter @ 71⁰F. Airlock bubbling once per second. This is a very good sign. Starting cooling process with a bit of water in tray but fan on the lowest setting.

• 2010-11-12 17:52 Fermenter @ 73⁰F. Krausen has entered the airlock! Incredibly active fermentation. Light cooling ineffective (too much heat release), and so stepping up the fan to its full speed.

• 2010-11-12 20:48 Fermenter @ 71⁰F. The lid has popped off from the amount of gas being produced! Reseating lid and replacing airlock fluid with boiled water.

• 2010-11-12 23:50 Fermenter @ 68°F. Cleaned and replaced airlock earlier (using cheap vodka, sorry J Hitz). It seems the fermentation has settled a bit. Airlock bubbling twice per second.

• 2010-11-13 13:15 Fermenter @ 66°F. Airlock bubbling once per second. Removing fan to let it heat back up to around 68⁰F.

• 2010-11-15 13:34 Fermenter @ 68°F. Temperature has stabilized here. Attenuation is winding down.

• 2010-11-17 14:22 Fermenter @ 70°F. Airlock bubbling twice per minute.

French Revolution

• BeerXML Recipe from Brewtarget

SteveKillen

Haystack Black Porter

• Black Porter (source)

Fermentation notes:

• 2010-12-09 17:40 @ 90°F: Wort unfortunately heated up because ClintonEbadi is an idiot and did not cool the malto dextrin water. Pitched before taking the reading, start cooling aggressively @ 18:15.

• 2010-12-09 20:30 @ 81°F: Airlock bubbling once every three seconds. Well then.

• 2010-12-09 21:45 @ 77°F: Airlock bubbling once every one two seconds.

• 2010-12-09 23:50 @ 74°F: Airlock bubbling once every second. Tshirt dry and track empty, resoaking and refilling.

• 2010-12-10 01:30 @ 71°F: Airlock bubbling twice per second. Target temperature reached (phew).

• 2010-12-10 02:30 - 04:00 @ 68°F: Undershot temperature a bit. During this time ClintonEbadi had to change the damn airlock several times because of krausen clogging. This is the last time the six gallon bucket is being used for fermenting as this has proven a persistent problem and ClintonEbadi likes to sleep sometimes.

• 2010-12-10 12:30 @ 63°F: Airlock managed to clog again and krausen has spilled all over the lid with a bit on the walls. SteveKillen can clean the bucket. Removing the wet tshirt as things are getting way too cold.

• 2010-12-10 14:45 @ 63°F: Airlock bubbling once every other second. Not clogged this time.

• 2010-12-10 20:28 @ 64°F: Airlock bubbling once every three seconds. Not warming very quickly.

• 2010-12-11 20:33 @ 68°F: Airlock bubbling once every four seconds. Managed to return to proper temperatures during the day.

• 2010-12-12 23:30 @ 71°F: Airlock bubbling once every eight seconds. Probably attenuated, allowing to warm a bit. The airlock does not smell strongly of esters and phenols as feared!

• 2010-12-13 20:50 @ 69°F: Airlock bubbling once every eight seconds.

• 2010-12-14 23:00 @ 69°F: Airlock bubbling once every ten seconds

• 2010-12-15 23:00 @ 68°F: No reading taken.

• 2010-12-26 14:58 @ 70°F: Held around this temperature since the 15th.

Luna Moth Saison

• LunaMothSaison (BeerXML from BrewTarget)

Very well received by Eddie & John at the FLHS. Of note: nice distinctive bubblegum aroma, not too heavily spiced, good balance between malt, alcohol, and hops. A keeper!

Steve's Extra Special

• Mystery Brew #1 (BeerXML from BrewTarget)

Wedding American Pale Ale

• Mystery Brew #2 (BeerXML from BrewTarget)

Bubonic Porter

• Mystery Brew #3 (BeerXML from BrewTarget)

Killen's Irish Red [planning]

• KillensIrishRed.xml (BeerXML from BrewTarget)

Stovetop Ales

Best Bitter

Version 1

• Stovetop Best Bitter (BeerXML from BrewTarget)

  #1 in a series of all-extract brews. Because...well, because we've never actually done any. We started out with specialty grains and LME, and I figured I'd take it back to the very basics and see what happens. The worst possibility is that it just tastes bad. But with over half a year of solid brewing under my belt, I don't think it will.

It turned out pretty well. The molasses took a while to tone down, but it had a nice hop spiciness to it.

Version 2

• Stovetop Best Bitter mk II (BeerXML from BrewTarget)

Second attempt with this recipe, on a slightly bigger kettle. Woo, a half-gallon more beer I changed the yeast and played with the hop schedule a bit to compensate for the fruitier yeast profile. More importantly, I tried adding most of the DME near the end of the boil rather than at the beginning.

Yowie, what a difference the late addition makes! Unfortunately, the Fuggles are missed on the palate, but the extra emphasis on the Kent Goldings yields an incredibly quaffable brew. In successive iterations, I'll walk the Fuggles back in.

Northern England Brown Ale

• Stovetop Northern England Brown Ale (BeerXML from BrewTarget) #2 in the series. Going to change only the malt base and a little bit of proportion, leaving the yeast and hop flavor intact. We racked onto the yeast cake of the first stovetop, so there was this weird "peatiness" (aka funk) that the old trub imparted. Next time I'll wash my yeast before reusing it.

Amber Ale

• Stovetop Amber Ale (BeerXML from BrewTarget) #3 in the series. SA-05, Cascade, and Centennial, but essentially the same malt base. No Irish moss this time. The clarity did, indeed, suffer, but the molasses is definitely the more noticeable element. Not really liking it at a pound; from here on out I'm keeping its use to 5-6% of the fermentables. It could stand to be better-bodied, too. But the Cascade comes through nicely!

Sorghum Ale (gluten-free)

• Shameless yoink of this recipe: http://homebrewexchange.net/content/gluten-free-mcgee-ale

  My take on it: Stovetop Sorghum Amber BeerXML: stovetopsorghumamber.xml

Some notes: A very low krausen during primary fermentation, but research indicates that this is typical. Quite lemony, almost like a hard lemonade at bottling.

American IPA

• Stovetop American IPA BeerXML: stovetopIPA.xml

Ended up a quart short, but gravity was spot on, so the top-up brought it up to the correct volume and gravity. My first full-boil batch on the stove with the new 5-gallon kettle! I racked this onto the sorghum yeast cake. I really need to start washing yeast.

JHitz

Brown Town

• Brown Ale (source)

Fermentation notes from ClintonEbadi:

• 2010-12-07 00:05 @ 71°F: Bubbling occasionally, thin krausen formed over ¾ of the wort surface

• 2010-12-07 01:41 @ 71°F: Bubbling once every 3-4 seconds. Solid krausen covering entire wort surface.

• 2010-12-07 03:05 @ 70°F: Bubbling once every 3-4 seconds. Krausen is at least an inch thick. Putting water into tray and wetting tshirt to reduce to primary fermentation temperatures.

• 2010-12-07 12:56 @ 66°F: Bubbling twice per second. Krausen is over two inches thick.

• 2010-12-07 15:15 @ 65°F: Bubbling rapidly. Krausen has grown further, and the wort is visibly churning.

• 2010-12-07 16:05 @ 66°F: Bubbling rapidly. Krausen has grown visibly.

• 2010-12-08 01:27 @ 65°F: Bubbling once per second. Krausen appears stable, and the wort is continuing to churn. Adding more water to the tray and resoaking tshirt.

• 2010-12-08 13:09 @ 63°F: Bubbling once per second. Wort activity has lessened. Target temperature undershot by a degree.

• 2010-12-08 17:42 @ 62°F: Bubbling once per second. Krausen has begun to recent. Water on tshirt has evaporated. Still under the ideal temperature, but within the range for Ringwood.

• 2010-12-08 19:50 @ 62°F. Replacing wet shirt with dry shirt, and removing from water tray to prevent a further drop in temperature.

• 2010-12-09 03:00 @ 64°F: Bubbling once every other second. Krausen has diminished significantly. Ideal temperature reached again.

• 2010-12-09 12:00 @ 66°F: Bubbling once every other second. Still in ideal temperature range.

• 2010-12-09 17:40 @ 66°F: Bubbling once every other second.

• 2010-12-09 23:50 @ 67°F: Bubbling once every three seconds. Krausen is about ½ inch thick.

• 2010-12-10 14:45 @ 68°F: Bubbling once every three seconds. Krausen has mostly dissipated.

• 2010-12-10 20:23 @ 68°F: Bubbling once every four seconds.

• 2010-12-26 14:43 @ 68°F: Held steady around this temperature since the 10th, ready to bottle

JWheatz

• recipe forthcoming

Recipes From Other Places

• Homebrewtalk Recipe Database Many from which to choose!

• Miller Lite Clone Why not? Up the OG to 1.060 and brew us some malt liquor breheims.